SEUIR Repository

Optimization of Sb2S3 sensitized solar cells by varying spinning cycles of light harvesting material

Show simple item record

dc.contributor.author Farhana, M.A
dc.contributor.author Bandara, J.
dc.date.accessioned 2023-08-09T03:51:41Z
dc.date.available 2023-08-09T03:51:41Z
dc.date.issued 2021-11
dc.identifier.citation Proceedings of Peradeniya University International Research Sessions 2021 (iPURSE), Sri Lanka, Vol. 23, 2021, pp:494 en_US
dc.identifier.isbn 978-624-5709-07-6
dc.identifier.uri http://ir.lib.seu.ac.lk/handle/123456789/6735
dc.description Proceedings of Peradeniya University International Research Sessions 2021, Sri Lanka, Vol. 23, 11th & 12th November 2021 en_US
dc.description.abstract Solid state sensitized solar cells have been intensively studied due to their promising cost-effectiveness and stability. Especially, many chalcogenides have been widely investigated as the light absorbing layer in solid-state sensitized solar cells. Among the chalcogenide solar cells, antimony sulfide (Sb2S3) is an excellent candidate for light absorption material in solar cells because of its unique characteristics, which are suitable for solar cell applications. Nevertheless, so far, the efficiency of planar configuration Sb2S3 solar cells is limited to 7%. However, compared to the higher power conversion efficiencies of the typical chalcogenide solar cells such as cadmium telluride (CdTe) and copper indium gallium selenide (CIGS), there are still many places to improve the Sb2S3- based solar cells. In this study, we investigated the performance of Sb2S3 solar cells, based on various spin coating cycles (1-4). The Sb2S3 precursor solution was prepared by mixing 228 mg of antimony chloride (SbCl3), 114 mg Thiourea and 1.5 ml of 2- methoxyethanol. The prepared solution was spin coated on TiO2 compact layer at 4000 rpm for 30 s. After spin coating of Sb2S3, the film was heated on the hot plate at 150 oC for 1 min and followed annealing inside the tube furnace at 280 oC for 10 mins under N2 stream. Then, a P3HT layer was used as a hole transport layer. Finally, 70 nm of thick silver (Ag) layer was deposited by thermal evaporation technique to form the top contact. With the final configuration of FTO/compact TiO2/Sb2S3/P3HT/Ag, a 3.63% power conversion efficiency was reached for two cycles of Sb2S3 precursor. The variation of Sb2S3 spinning cycles, significantly controls the device performance. UV-Vis absorption, IPCE and EIS spectra were obtained to characterize the devices and they were in a good agreement. Further improvement of the solar cell performance is underway. en_US
dc.language.iso en_US en_US
dc.publisher University of Peradeniya Peradeniya, Sri Lanka en_US
dc.subject Sb2S3 en_US
dc.subject Solid state solar cell en_US
dc.subject Spinning cycles en_US
dc.subject Light harvesting en_US
dc.title Optimization of Sb2S3 sensitized solar cells by varying spinning cycles of light harvesting material en_US
dc.type Article en_US


Files in this item

This item appears in the following Collection(s)

  • Research Articles [915]
    THESE ARE RESEARCH ARTICLES OF ACADEMIC STAFF, PUBLISHED IN JOURNALS AND PROCEEDINGS ELSWHERE

Show simple item record

Search SEUIR


Advanced Search

Browse

My Account